How We Repair Your SunQuest Tanning Bed
Equipment such as tanning beds and air compressors combine motors, electrical controls, lamps or pumps that wear with use.
SunQuest Tanning Bed models often use model-specific control boards, sensors and diagnostic modes. We look up your exact model number so the right part goes in the first time.
Common Tanning Bed Problems We Fix
Trips breakers
A short in wiring or a failing motor.
Will not start
A failed switch, timer, capacitor or pressure switch.
Runs but underperforms
Worn lamps, leaks in hoses or fittings, or a worn pump.
Overheats
Blocked cooling, a failed fan or overuse.
Quick Checks Before You Call
These are safe for most owners and sometimes solve the problem without a visit:
- Check the breaker and power cord
- Clean filters and cooling vents
- Drain compressor tanks
Still not working? Call (844) 442-1500 or try our troubleshooting wizard.
Our 5-Step Repair Process
- Call or book onlineTell us what your SunQuest tanning bed is doing and when it started. We schedule the first available visit.
- DiagnosisThe technician checks power, controls and the parts most likely to fail, using the model's service data and test modes.
- Upfront quoteYou get the cause, the repair and the price before any work starts. If repair does not make sense, we tell you.
- RepairWe install original or equivalent parts matched to your model and clean up when we are done.
- Test and warrantyWe run the appliance through a full cycle to confirm the fix. The repair is covered by our 90-day parts and labor warranty.
Parts We Replace Most Often
- Motors
- Capacitors
- Pressure switches
- Lamps and ballasts
- Timers
- Fans
Cost and Lifespan
Most tanning bed repairs cost $100–$450 including parts and labor, and these appliances typically last 8–15 years. These are national estimates: your exact price comes after the diagnosis. Use the repair vs replace calculator to compare.
Keep It Running Longer
- Replace lamps as a set
- Follow the maker's maintenance schedule
- Drain compressor tanks after use
Tanning Bed Repair in Slatington, PA
We repair tanning beds in Slatington (ZIP code 18080) and in nearby communities including Walnutport, Schnecksville and Palmerton. Humid summers and long, cold winters in Pennsylvania give Slatington appliances a busy year, with heavy indoor use from fall to spring.
Frequently Asked Questions
How much does SunQuest Tanning Bed Repair cost in Slatington, PA?
Most tanning bed repairs fall between $100–$450 including parts and labor. The final price depends on the part that failed and your model. You get an exact quote after the diagnosis and before any work starts.
Can you repair my tanning bed today?
Same-day visits depend on technician availability in Slatington. Call (844) 442-1500 early in the day for the best chance of a same-day or next-day appointment.
Is the repair guaranteed?
Yes. Parts and labor are covered by our 90-day warranty. If the same problem comes back within that time, we return and fix it.
Do you work on all SunQuest models?
We repair current and older SunQuest models. Some discontinued parts can be hard to find; if that is the case for your model, we tell you before you pay for a repair.
Should I repair or replace my tanning bed?
A tanning bed typically lasts about 8 to 15 years. If yours is well inside that range and the repair costs less than half the price of a new one, repairing usually makes sense. Near the end of its life, or when the repair costs more than half of a replacement, replacing is often the better value. We give you an honest opinion either way.